Register
Filter

Highest voted questions

0 votes
0 answers
681
GATE Electrical 2013 | Question: 47
When the $\text{Newton-Raphson}$ method is applied to solve the equation $f(x)=x^3+2x-1=0$ ,the solution at the end of the first iteration with the initial guess value as $x_0$ =$1.2$ is $-0.82$ $0.49$ $0.705$ $1.69$
When the $\text{Newton-Raphson}$ method is applied to solve the equation $f(x)=x^3+2x-1=0$ ,the solution at the end of the first iteration with the initial guess value a...
0 votes
0 answers
685
GATE Electrical 2013 | Question: 46
A function $y=5x^2+10x$ is defined over an open interval $x$ = $(1, 2)$ . At least at one point in this interval, $\dfrac{\mathrm{dy} }{\mathrm{d} x}$ is exactly $20$ $25$ $30$ $35$
A function $y=5x^2+10x$ is defined over an open interval $x$ = $(1, 2)$ . At least at one point in this interval, $\dfrac{\mathrm{dy} }{\mathrm{d} x}$ is exactly$20$$25$$...
0 votes
0 answers
689
GATE Electrical 2013 | Question: 45
A $4$ – pole induction motor, supplied by a slightly unbalanced three-phase $50 Hz$ source, is rotating at $1400\:rpm$. The electrical frequency in $Hz$ of the induced negative sequence current in the rotor is $100$ $98$ $52$ $48$
A $4$ – pole induction motor, supplied by a slightly unbalanced three-phase $50 Hz$ source, is rotating at $1400\:rpm$. The electrical frequency in $Hz$ of the induced ...
0 votes
0 answers
690
GATE Electrical 2013 | Question: 36
$\displaystyle{}\int \frac{z^2-4}{z^2+4}\: dz$ evaluated anticlockwise around the circle $\mid z-i \mid=2$ , where $i=\sqrt{-1}$, is $-4\pi$ $0$ $2+\pi$ $2+2i$
$\displaystyle{}\int \frac{z^2-4}{z^2+4}\: dz$ evaluated anticlockwise around the circle $\mid z-i \mid=2$ , where $i=\sqrt{-1}$, is$-4\pi$$0$$2+\pi$$2+2i$
0 votes
0 answers
691
GATE Electrical 2013 | Question: 39
In the circuit shown below the op-amps are ideal. Then $V_{out}$ in Volts is $4$ $6$ $8$ $10$
In the circuit shown below the op-amps are ideal. Then $V_{out}$ in Volts is$4$$6$$8$$10$
0 votes
0 answers
694
GATE Electrical 2013 | Question: 40
The signal flow graph for a system is given below. The transfer function $\dfrac{Y(s)}{U(s)}$ for this system is $\dfrac{s+1}{5s^2+6s+2} \\$ $\dfrac{s+1}{s^2+6s+2} \\$ $\dfrac{s+1}{s^2+4s+2} \\$ $\dfrac{1}{5s^2+6s+2}$
The signal flow graph for a system is given below. The transfer function $\dfrac{Y(s)}{U(s)}$ for this system is$\dfrac{s+1}{5s^2+6s+2} \\$$\dfrac{s+1}{s^2+6s+2} \\$$\d...
0 votes
0 answers
695
GATE Electrical 2013 | Question: 41
The impulse response of a continuous time system is given by $h(t)=\delta (t-1)+\delta (t-3).$ The value of the step response at $t=2$ is $0$ $1$ $2$ $3$
The impulse response of a continuous time system is given by $h(t)=\delta (t-1)+\delta (t-3).$ The value of the step response at $t=2$ is$0$$1$$2$$3$
0 votes
0 answers
707
GATE Electrical 2013 | Question: 24
Given a vector field $\textbf{F}=y^2x \textbf{a}_x-yz \textbf{a}_y-x^2 \textbf{a}_z$ the line integral $\int \textbf{F} \cdot d \textbf{l}$ evaluated along a segment on the $x$-axis from $x=1$ to $x=2$ is $-2.33$ $0$ $2.33$ $7$
Given a vector field $\textbf{F}=y^2x \textbf{a}_x-yz \textbf{a}_y-x^2 \textbf{a}_z$ the line integral $\int \textbf{F} \cdot d \textbf{l}$ evaluated along a segment on t...
0 votes
0 answers
709
GATE Electrical 2013 | Question: 31
A voltage $1000 \sin \omega t$ Volts is applied across $YZ$. Assuming ideal diodes, the voltage measured across $WX$ in Volts is $\sin \omega t$ $(\sin \omega t + \sin \omega t ) / 2$ $(\sin \omega t - \sin \omega t ) / 2$ $0$ for all $t$
A voltage $1000 \sin \omega t$ Volts is applied across $YZ$. Assuming ideal diodes, the voltage measured across $WX$ in Volts is$\sin \omega t$$(\sin \omega t + \sin \ome...
0 votes
0 answers
711
GATE Electrical 2013 | Question: 18
A band-limited signal with a maximum frequency of $5\:kHz$ is to be sampled. According to the sampling theorem, the sampling frequency in $kHz$ which is not valid is $5$ $12$ $15$ $20$
A band-limited signal with a maximum frequency of $5\:kHz$ is to be sampled. According to the sampling theorem, the sampling frequency in $kHz$ which is not valid is$5$$1...
0 votes
0 answers
712
GATE Electrical 2013 | Question: 14
The input impedance of the permanent magnet moving coil $(PMMC)$ voltmeter is infinite. Assuming that the diode shown in the figure below is ideal, the reading of the voltmeter in Volts is $4.46$ $3.15$ $2.23$ $0$
The input impedance of the permanent magnet moving coil $(PMMC)$ voltmeter is infinite. Assuming that the diode shown in the figure below is ideal, the reading of the vol...
0 votes
0 answers
713
GATE Electrical 2013 | Question: 21
Leakage flux in an induction motor is flux that leaks through the machine flux that links both stator and rotor windings flux that links none of the windings flux that links the stator winding or the rotor winding but not both
Leakage flux in an induction motor isflux that leaks through the machineflux that links both stator and rotor windingsflux that links none of the windingsflux that links ...
0 votes
0 answers
714
GATE Electrical 2013 | Question: 17
For a periodic signal $v(t) = 30 \sin100t +10 \cos 300t + 6 \sin (500t+\pi /4)$, the fundamental frequency in $rad/s$ is $100$ $300$ $500$ $1500$
For a periodic signal $v(t) = 30 \sin100t +10 \cos 300t + 6 \sin (500t+\pi /4)$, the fundamental frequency in $rad/s$ is$100$$300$$500$$1500$
0 votes
0 answers
720
GATE Electrical 2013 | Question: 10
The flux density at a point in space is given by $\textbf{B}=4x \textbf{a}_x+2ky \textbf{a}_y+8 \textbf{a}_z \:\: Wb/m^2$. The value of constant $k$ must be equal to $-2$ $-0.5$ $+0.5$ $+2$
The flux density at a point in space is given by $\textbf{B}=4x \textbf{a}_x+2ky \textbf{a}_y+8 \textbf{a}_z \:\: Wb/m^2$. The value of constant $k$ must be equal to$-2$...
Page: