Recent questions tagged electrical-and-electronic-measurements

The resistance values of the Wheatstone bridge shown are: $\mathrm{P}=2000 \Omega, \mathrm{Q}=500 \Omega, \mathrm{R}=3000 \Omega$. The battery voltage $\mathrm{E}=50 \mat...

The maximum percentage error in the equivalent resistance of two parallel-connected resistors of $100 \: \Omega$ and $900 \: \Omega$ with each having a maximum $5 \%$ err...

In an experiment to measure the active power drawn by a single-phase RL Load connected to an AC source through a $2\: \Omega$ resistor, three voltmeters are connected as ...

In the Wheatstone bridge shown below, the sensitivity of the bridge in terms of change in balancing voltage $E$ for unit change in the resistance $R$, in $\mathrm{mV} / \...

A balanced Wheatstone bridge $\text{ABCD}$ has the following arm resistances: $R_{AB} = 1\:k\Omega \: \pm \:2.1\%; \:R_{BC} = 100\:\Omega \:\pm \:0.5\%; \: R_{CD}$ is an ...

Inductance is measured bySchering bridgeMaxwell bridgeKelvin bridgeWien bridge

The total impedance of the secondary winding, leads, and burden of a $5$ A CT is $0.01 \: \Omega$. If the fault current is $20$ times the rated primary current of the CT,...

A moving coil instrument having a resistance of $10 \: \Omega$, gives a full-scale deflection when the current is $10$ mA. What should be the value of the series resistan...

An analog voltmeter uses external multiplier settings. With a multiplier setting of $20 \: k \Omega$, it reads $440$ V and with a multiplier setting of $80 \: k \Omega$, ...

The bridge method commonly used for finding mutual inductance isHeaviside Campbell bridgeSchering bridgeDe Sauty bridgeWien bridge

A periodic voltage waveform observed on an oscilloscope across a load is shown. A permane magnet moving coil (PMMC) meter connected across the same load reads$4$V$5$ V$8$...

A $0-1$ Ampere moving iron ammeter has an internal resistance of $50 \: m \Omega$ and inductance of $0.1 \: mH$. A shunt coil is connected to extend its range to $0-10$ A...

A $10 \frac{1}{2}$ digit timer counter possesses a base clock of frequency $100$ MHz. When measuring a particular input, the reading obtained is the same in:Frequency mod...

Two resistors with nominal resistance values $R_{1}$ and $R_{2}$ have additive uncertainties $\bigtriangleup R_{1}$ and $\bigtriangleup R_{2}$, respectively. When these r...

A stationary closed Lissajous pattern on an oscilloscope has $3$ horizontal tangencies and $2$ vertical tangencies for a horizontal input with frequency $3$kHz. The frequ...

The following measurements are obtained on a single phase load $V=220 V \pm 1$%, $I=5.0 A \pm 1$% and $W=555 W \pm 2$%. If the power factor is calculated using these meas...

The slope and level detector circuit in a $CRO$ has a delay of $100$ns. The start - stop sweep generator has a response time of $50$ns. In order to display correctly, a d...