Register
Filter

Recent questions without an upvoted answer

0 votes
0 answers
761
GATE Electrical 2014 Set 2 | Question: 45
For the transfer function $G(s)=\dfrac{5(s+2)}{s(s+0.25)(s^2+4s+25)}$ The values of the constant gain term and the highest corner frequency of the Bode plot respectively are $3.2$ , $5.0$ $16.0$ , $4.0$ $3.2$ , $4.0$ $16.0$ , $5.0$
For the transfer function $$G(s)=\dfrac{5(s+2)}{s(s+0.25)(s^2+4s+25)}$$ The values of the constant gain term and the highest corner frequency of the Bode plot respectivel...
0 votes
0 answers
767
GATE Electrical 2014 Set 2 | Question: 29
Assuming the diodes to be ideal in the figure, for the output to be clipped, the input voltage $v_i$ must be outside the range $-1$ $V$ to $-2$ $V$ $-2$ $V$ to $-4$ $V$ $+1$ $V$ to $-2$ $V$ $+2$ $V$ to $-4$ $V$
Assuming the diodes to be ideal in the figure, for the output to be clipped, the input voltage $v_i$ must be outside the range$-1$ $V$ to $-2$ $V$$-2$ $V$ to $-4$ $V$$+1$...
0 votes
0 answers
769
GATE Electrical 2014 Set 2 | Question: 31
The total power dissipated in the circuit, shown in the figure, is $1$ $kW$. The voltmeter, across the load, reads $200$ $V$. The value of $X_L$ is ___________.
The total power dissipated in the circuit, shown in the figure, is $1$ $kW$.The voltmeter, across the load, reads $200$ $V$. The value of $X_L$ is ___________.
0 votes
0 answers
772
GATE Electrical 2014 Set 2 | Question: 34
An input signal $x(t)=2+5 \sin(100\pi t)$ is sampled with a sampling frequency of $400$ $Hz$ ... where, $N$ represents the number of samples per cycle. The output $y(n)$ of the system under steady state is $0$ $1$ $2$ $5$
An input signal $x(t)=2+5 \sin(100\pi t)$ is sampled with a sampling frequency of $400$ $Hz$ and applied to the system whose transfer function is represented by $$\dfrac...
0 votes
0 answers
778
GATE Electrical 2014 Set 2 | Question: 17
The closed loop transfer function of a system is $T(s)=\dfrac{4}{s^2+0.4S+4}$ The steady state error due to unit step input is __________.
The closed loop transfer function of a system is $T(s)=\dfrac{4}{s^2+0.4S+4}$ The steady state error due to unit step input is __________.
0 votes
0 answers
780
GATE Electrical 2014 Set 2 | Question: 19
The saw-tooth voltage waveform shown in the figure is fed to a moving iron voltmeter. Its reading would be close to _____________
The saw-tooth voltage waveform shown in the figure is fed to a moving iron voltmeter. Its reading would be close to _____________
0 votes
0 answers
781
GATE Electrical 2014 Set 2 | Question: 20
While measuring power of a three-phase balanced load by the two-wattmeter method, the readings are $100$ $W$ and $250$ $W$. The power factor of the load is ______.
While measuring power of a three-phase balanced load by the two-wattmeter method, the readings are $100$ $W$ and $250$ $W$. The power factor of the load is ______.
0 votes
0 answers
782
GATE Electrical 2014 Set 2 | Question: 21
Which of the following is an invalid state in an $8$-$4$-$2$-$1$ Binary Coded Decimal counter $1$ $0$ $0$ $0$ $1$ $0$ $0$ $1$ $0$ $0$ $1$ $1$ $1$ $1$ $0$ $0$
Which of the following is an invalid state in an $8$-$4$-$2$-$1$ Binary Coded Decimal counter$1$ $0$ $0$ $0$$1$ $0$ $0$ $1$$0$ $0$ $1$ $1$$1$ $1$ $0$ $0$
0 votes
0 answers
783
GATE Electrical 2014 Set 2 | Question: 22
The transistor in the given circuit should always be in active region. Take $V_{CE(sat)}$ = $0.2$ $V$ , $V_{BE}$=$0.7$ $V$. The maximum value of $R_c$ in $Ω$ which can be used, is ______________.
The transistor in the given circuit should always be in active region. Take $V_{CE(sat)}$ = $0.2$ $V$ , $V_{BE}$=$0.7$ $V$. The maximum value of $R_c$ in $Ω$ which can b...
0 votes
0 answers
789
GATE Electrical 2014 Set 2 | Question: 28
The minimum value of the function $f(x)=x^3-3x^2-24x+100$ in the interval $[-3,3]$ is $20$ $28$ $16$ $32$
The minimum value of the function $f(x)=x^3-3x^2-24x+100$ in the interval $[-3,3]$ is$20$$28$$16$$32$
0 votes
0 answers
790
GATE Electrical 2014 Set 2 | Question: 5
Consider the differential equation $x^2\dfrac{d^2y}{dx^2}+x\dfrac{dy}{dx}-y=0$. Which of the following is a solution to this differential equation for $x>0$? $e^x$ $x^2$ $1/x$ $\ln x$
Consider the differential equation $x^2\dfrac{d^2y}{dx^2}+x\dfrac{dy}{dx}-y=0$. Which of the following is a solution to this differential equation for $x>0$?$e^x$$x^2$$1/...
0 votes
0 answers
791
GATE Electrical 2014 Set 2 | Question: 6
Two identical coupled inductors are connected in series. The measured inductances for the two possible series connections are $380$ $μH$ and $240$ $μH$. Their mutual inductance in $μH$ is ________
Two identical coupled inductors are connected in series. The measured inductances for the two possible series connections are $380$ $μH$ and $240$ $μH$. Their mutual in...
0 votes
0 answers
794
GATE Electrical 2014 Set 2 | Question: 9
Consider an LTI system with transfer function $H(s)=\frac{1}{s(s+4)}$ If the input to the system is $ \cos(3t)$ and the steady state output is $A \sin(3t+\alpha )$ , then the value of $A$ is $1/30$ $1/15$ $3/4$ $4/3$
Consider an LTI system with transfer function $$H(s)=\frac{1}{s(s+4)}$$ If the input to the system is $ \cos(3t)$ and the steady state output is $A \sin(3t+\alpha )$ , th...
0 votes
0 answers
795
GATE Electrical 2014 Set 2 | Question: 10
Consider an $LTI$ system with impulse response $h(t)=e^{-5t}u(t)$ . If the output of the system is $y(t)=e^{-3t}u(t)-e^{-5t}u(t)$ then the input, $x(t)$, is given by $e^{-3t}u(t)$ $2e^{-3t}u(t)$ $e^{-5t}u(t)$ $2e^{-5t}u(t)$
Consider an $LTI$ system with impulse response $h(t)=e^{-5t}u(t)$ . If the output of the system is $y(t)=e^{-3t}u(t)-e^{-5t}u(t)$ then the input, $x(t)$, is given by$e^{...
0 votes
0 answers
797
GATE Electrical 2014 Set 2 | Question: 12
A single phase, $50$ $kVA$, $1000V$/$100V$ two winding transformer is connected as an autotransformer as shown in the figure. The $kVA$ rating of the autotransformer is _____________.
A single phase, $50$ $kVA$, $1000V$/$100V$ two winding transformer is connected as an autotransformer as shown in the figure.The $kVA$ rating of the autotransformer is __...
Page: